- Idea for project : an interactive installation, experienced by two people at a time
- Things to consider, how to nicley hide all the wires yet get the effect desired
- Kinetic sculpture
Arduino Board
- Tilt sensor with 2 servos
Steps :
Hardware :
Servo and titl sensor
** Place the tilt sensor on the breadboard, connect the pins, one to the - on the board, keep middle empty, the last to the arduino, one of the digital pins. To know which is ground and which is power, refer back to the manual.
** Then add a resistor with 10 kΩ connecting from the + side of the tilt sensor
- Tilt sensor with passive buzzers + adding different tones
- Using the magic cup tilt sensor for lights
Design wise
Videos
Kinetic Sculpture Experiment 02 from Farah Hijazi on Vimeo.
Kinetic Sculpture Experiment from Farah Hijazi on Vimeo.